Smart home host performance indicators and installation requirements

1. Performance indicators

(1) Video Resolution: 4-way CIF, 352x288.

(2) Video compression format: Mpeg4.

(3) Video format: PAL format.

(4) Maximum frame rate: 4x25 frames in real time.

(5) Video bandwidth: 64K to 2Mbps adjustable.

(6) Wireless video frequency: 2.4G.

(7) 32-channel wireless alarm receiving frequency: 315M.

(8) 32-channel wireless input encoding format: PT2262/2272 encoding format or 1527 encoding format.

(9) 32-channel wireless output frequency: 315M.

(10) 32-channel wireless output encoding format: PT2262/2272 encoding format or 1527 encoding format.

(11) 16-channel wired alarm input signal: Passive switch is normally closed, disconnected is alarm.

(12) 6-channel wired output signal: 500mA TTL level signal, can be connected to relays and so on.

(13) 1 wire siren output signal: 2A, l2Y switch signal, can be directly connected to the siren.

(14) Network Interface: 100M Ethernet.

(15) Display interface: VGA and AV dual display.

(16) Telephone interface: PSTN telephone interface.

2. Installation requirements

1) Hardware Installation

(1) Front panel. The front panel is mainly keyboard and indicator light. The functions of the keyboard keys vary according to the menu.

(2) Rear panel. The rear panel is a variety of wiring ports, mainly VGA interface, video interface, network interface, telephone interface, and I / O input / output interface.

2) System requirements

(1) You need a TV or monitor, or a monitor.

(2) Some alarm detector connection lines are required, and 4-core telephone lines can be used instead.

(3) If you want to watch videos on your mobile phone, your mobile phone should be able to access the internet.

(4) A telephone line that can dial the local call is needed.

(5) The mainframe is installed in a ventilated, dry and direct indoor environment.

(6) For 220V power supply, it is better to have standby power supply such as UPS. There is no backup power in the machine.

3) Installation conditions

(1) Install the camera and connect the video cable to the video input connector. Up to 4 images can be connected. Among them, the first and second ways can be either wired or wireless access modes, and one of them can be selected.

(2) Install and connect various wired probes.

(3) Connect the video output to a TV or monitor.

(4) Install various probes for wireless access. If it is your own wireless probe, you need to enter it into the host to be recognized by the host.

(5) Install smart home wireless control switch. If you choose to buy switch equipment, you need to enter the host to be recognized by the host.